Range of Battery pack testers for both NiCd / NiMH batteries as well as lithium polymer (lipo) batteries.
LED battery status indicator for 4.8 - 6.0V batteries
Can also be used for 6V lead-acid batteries.
Green lights show good battery, as the battery drains
lights change, eventually the end LED which is red
illuminates. Switch at the side selects 4.8V/6.0V
Connection is JR/Hitec type.
LED battery status indicator & alarm for 1S to 3S
(3.7 - 11.1V)
Simple green light = good, flashing red light = low, for
each cell. Buzzer sounds when battery voltage falls
dangerously low
Connect to any lipo with balance connector with 0.1”
pitch (2.54mm) connections, such as the JST-XH
type as fitted to all our lipo batteries.
7-Segment display battery status indicator for 2S to 6S
(7.4 - 22.2V)
Display shows actual cell voltage, cycling through all
the cells of the battery & then starting from the
beginning again.
Connect to any lipo with balance connector with 0.1”
pitch (2.54mm) connections, such as the JST-XH
type as fitted to all our lipo batteries.
LED battery status indicator for 2S to 3S (7.4 - 11.1V)
Simple green light = good, red light = low for each
cell.
Connect to any lipo with balance connector with 0.1”
pitch (2.54mm) connections, such as the JST-XH
type as fitted to all our lipo batteries.
LED battery status indicator for 4.8 - 8.4V batteries
4 - 7 cell battery packs.
Can also be used for 6V lead-acid batteries.
Green lights show good battery, as the battery drains
lights change, eventually the end LED which is red
illuminates. Switches at the rear select voltage
Connection is JR/Hitec type.
Copyright © component-shop.co.uk ltd 2012 All rights reserved
Registered in England & Wales No: 5614975
7-Segment display battery status indicator for 2S to 6S
(7.4 - 22.2V) with hard-case.
Same tester as above, but in hard plastic case to
protect it in the toolkit. Also has clip-on cap to
protect the pins.
Connect to any lipo with balance connector with 0.1”
pitch (2.54mm) connections, such as the JST-XH
type as fitted to all our lipo batteries.
7-Segment display battery status indicator for 2S to 8S
(7.4 - 29.6V) with programmable voltage & alarm.
Display shows actual cell voltage, cycling through all
cells automatically & then giving the total pack voltage.
Alarm will sound when any cell voltage drops below a
level which can be set betwee 2.7V & 3.8V.
Connect to any lipo with balance connector with 0.1”
pitch (2.54mm) connections, such as the JST-XH
type as fitted to all our lipo batteries.
